Don't leave your bike in the cold

wd40

Published on 14 November 2014 by Gill

Tags: ,

Filed under Category: Tips and advice

As winter draws ever closer and the weather starts to get colder and wetter, it’s time to think about putting your motorbike into hibernation to protect it. If you’re thinking about putting your bike away, WD-40 has prepared some handy motorbike maintenance tips to ensure you can take to the roads safely as soon as the weather perks up in the spring.

Keep it slick – Oil left to rest in the engine can form a thick black sludge, which over time can corrode parts of the engine and cause serious damage. Therefore, we recommend changing the oil before the bike goes into hibernation for the season - the best time to change the oil is just after your last ride so the engine is still warm, making the oil easier to remove or alternatively you can leave the engine to run for a while before you get to work.

Don’t let it drain – When your bike is left in storage in a cold environment, the battery will start to drain flat. The best option is to remove the battery and store it somewhere safe and dry until it next needs to be used. You can also use a trickle charger to feed the battery with a low stream of electricity throughout the winter months - this can help lengthen the battery’s lifespan.

Tread carefully – The performance of tyre rubber can be detrimentally affected when exposed to cold/freezing temperatures. It is therefore recommended that paddock stands are used to keep tyres away from the cold temperatures of the flooring – especially if stored in a garage. If you don’t have any paddock stands to hand, you can also use safely secured blocks of wood to keep your bike raised from the ground.

Protect – Ensure you remove any dirt and grime from your chain and lubricate it for an added layer of protection. WD-40 Specialist Chain Wax will provide long-lasting protection throughout the winter and prevent the chain from corroding. Clutch and brake cables can be protected by spraying a small amount of WD-40 Multi-Use Product down the cable housing. Operate the levers to work the lubricant as far down the cable as possible – this prevents any damage caused by moisture. A quick wipe of WD-40 Multi-Use Product can also help shield exposed areas of the motorbike from rusting, such as the frame and engine.

Wash and Wax – Clean your bike thoroughly, WD-40 Specialist Motorbike Total Wash is great at cutting through traffic film and road grime that has collected on the bike’s surface and removing any potentially corrosive material that could damage paintwork and other vital components. Once the surface is dirt free, WD-40’s Specialist Motorbike Wax and Polish can be used to repel any water should the bike become exposed to damp conditions, leaving paintwork streak-free and with a glossy shine.

Last but not least, invest in a bike cover for an extra layer of protection from any dust and dirt. This will ensure all your hard work doesn’t go to waste and your bike is ready to ride as soon as the weather starts to clear.

For more information on the WD-40 Specialist Motorbike range visit the website here